Re: [NTLK] Newbie question about transferring data from one

From: Robert Serna (japecan_at_newted.dyndns.org)
Date: Tue Dec 09 2003 - 06:37:00 PST


Peter wrote =
OK,
Comm1 is set to 9600,8,n,1 - flow control none, FIFO is disabled on my laptop. I restarted the laptop,
shut done the MP 120. With a fresh instance of XP running I fired up NCU and made sure that Comm1 was selected. The laptop
and the Newton are connected
already. I turned on the MP 120 and tapped extras, tapped
connection, made sure that "Serial
-------------------
I think a list member earlier did suggest NCK instead of NCU! also whenever I connect with my MP2100 I set it to serial ONLY and my NCU to 38000 with 1 slow down installed & I'm using Win 98 se with a Belkin F5U103 usb ! Also try using the various serial settings on your Newton like the faq suggests & try Com port 3 on your win xP I do! hope that helps! Gotta go & pick up my girlfriend from work now & well check later to see if this did the trick! Remember NCU=os2.0 & NCK= anything lower if I remember correctly!
sent with a Newton Message Pad 2100

-- 
This is the NewtonTalk list - http://www.newtontalk.net/ for all inquiries
List FAQ/Etiquette/Terms: http://www.newtontalk.net/faq.html
Official Newton FAQ: http://www.chuma.org/newton/faq/


This archive was generated by hypermail 2.1.5 : Tue Dec 09 2003 - 23:00:00 PST