[NTLK] Screw size for interconnect port

Andrei Chichak newton at chichak.ca
Sun Apr 24 18:33:27 EDT 2011


Sorry, this was for the internal port.


On 2011-April-24, at 3:51 PM, Andrei Chichak wrote:

> I was just digging around in my electronics workbench and found the screws that would hold down a board on the interconnect port.
> 
> I had previously figured out that the boss will accommodate a 1-72 1/4" flat head screw. I found some at my local hobby store in the model railroad section.
> 
> Andrei
> 
> 
> ==================================================================== 
> The NewtonTalk Mailing List - http://newtontalk.net/
> The Official Newton FAQ     - http://splorp.com/newton/faq/
> The Newton Glossary         - http://splorp.com/newton/glossary/
> WikiWikiNewt                - http://tools.unna.org/wikiwikinewt/
> ====================================================================
> 





More information about the NewtonTalk mailing list