[NTLK] NCU and MacOS X on PB G3

From: andrew_at_misf67.cern.ch
Date: Thu Oct 24 2002 - 12:11:36 EDT


Hello,

I finally have started to switch and I have installed MacOs X (10.1.5) on
my good old Powerbook G3 (250MHz). It is faster than I had expected. This
machine has a real derial port.

But, when I start NCU (in classic) I get an error 78 because it could not
configure the printer-modem port. The only possibility seems to be
connecting via appletalk. Does anyone know how to make the serial port
available again for NCU under classic??

Thanks,
                 Andrew

-- 
--
Andrew Maier
Andrew.Maier_at_cern.ch
God is real, unless declared integer

-- Read the List FAQ/Etiquette: http://www.newtontalk.net/faq.html Read the Newton FAQ: http://www.chuma.org/newton/faq/ This is the NewtonTalk mailing list - http://www.newtontalk.net/



This archive was generated by hypermail 2.1.2 : Thu Oct 31 2002 - 12:03:40 EST